408-10021 datasheet(2/5 Pages) MACOM

2 / 5 page

408- 10021

CERTI- CRIMP II Tool Holder Assembly 1213860- 1

Rev C

of 5

Tyco Electronics Corporation

Figure 2

Quick--Release Pin

Housing Center

Switch (Handle)

Housing

Side

Housing

Side

3. INSTALLATION AND REMOVAL

3.1. Installation and Removal of the CERTI- CRIMP II

Tool Holder Assembly 1213860- 1

A. Installation

Before mounting the CERTI--CRIMP II Tool Holder

Assembly, always make sure the guide ram of the

terminator is in the lowest position. See Figure 3.

To avoid personal injury, be sure the SDE Electric

Bench Terminator is disconnected from the power

source prior to the installation or removal of the

tool holder assembly.

1. Be sure that the terminator has been switched

off.

2. Be sure that the CERTI--CRIMP II tool holder

assembly is mounted with the switch (handle) in

the front, to facilitate die opening and closing.

3. Mount the tool holder assembly from the back

and lock with the guide (safety) pins. Refer to

Figure 3 and Figure 4.

4. Refer to Paragraph 3.2, to remove and install

the crimping dies.

B. Removal

To avoid personal injury, be sure the SDE Electric

Bench Terminator is disconnected from the power

source prior to the installation or removal of the

tool holder assembly.

1. Be sure the terminator has been switched “off.”

2. Remove the locating pins from the tool holder

assembly.

3. Remove and/or replace the tool holder

assembly.

4. When removing the tool holder assembly, make

sure that the guide ram of the terminator is in the

lowest position.

5. If installing or removing crimping dies, refer to

Paragraph 3.2.

3.2. Installation and Removal of CERTI- CRIMP II

Crimping Heads

To avoid personal injury, be sure the SDE Electric

Bench Terminator is disconnected from the power

source prior to the installation or removal of the

crimping heads.

As supplied, the tool holder assembly has three

quick--release pins installed (Figure 2 and Figure 4 ).

The two outer pins will be used to secure the two

outer housing tabs of the crimp head (exposed

portion of the crimp head) to the tool holder assembly.

DANGER

408-10021 bảng dữ liệu(PDF) 2 Page - Tyco Electronics

408-10021 bảng dữ liệu(HTML) 2 Page - Tyco Electronics

Html Pages

1 2 3 4 5

bảng dữ liệu tải về

Link URL