QS10.DNET

Q-Series

Page

Page

1.

Intended Use .......................................................3

2.

Installation Requirements...................................3

3.

AC-Input...............................................................4

4.

DC-Input...............................................................5

5.

Input Inrush Current ...........................................5

6.

Output .................................................................6

7.

Hold-up Time.......................................................7

8.

DC-OK Relay Contact ..........................................7

9.

Efficiency and Power Losses................................8

10. Reliability .............................................................9

11. Functional Diagram...........................................10

12. Terminals and Wiring........................................10

13. Front Side and User Elements...........................11

14. EMC....................................................................12

15. Environment ......................................................13

16. Protection Features ...........................................14

17. Safety Features ..................................................14

18. Dielectric Strength ............................................15

19. Approvals...........................................................16

20. Physical Dimensions and Weight ..................... 17

21. Accessories ........................................................ 18

21.1. ZM1.WALL Wall Mounting Bracket .......18

21.2. ZM13.SIDE Side Mounting Bracket ........18

21.3. UF20.241 Buffer Module ..........................18

22. Application Notes............................................. 19

22.1. Peak Current Capability ...........................19

22.2. Back-feeding Loads ..................................19

22.3. External Input Protection.........................20

22.4. Charging of Batteries ...............................20

22.5. Output Circuit Breakers............................20

22.6. Parallel Use to Increase Output Power....21

22.7. Parallel Use for Redundancy ....................21

22.8. Series Operation .......................................21

22.9. Inductive and Capacitive Loads................21

22.10. Operation on Two Phases ........................21

22.11. Use in a Tightly Sealed Enclosure ............21

The information presented in this document is believed to be accurate and reliable and may change without notice.

No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.

PE and

symbol

PE is the abbreviation for Protective Earth and has the same meaning as the symbol

.

Earth, Ground

This document uses the term “earth” which is the same as the U.S. term “ground”.

T.b.d.

To be defined, value or description will follow later.

AC 230V

A figure displayed with the AC or DC before the value represents a nominal voltage with

standard tolerances (usually ±15%) included.

E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)

230Vac

A figure with the unit (Vac) at the end is a momentary figure without any additional

tolerances included.

50Hz vs. 60Hz

As long as not otherwise stated, AC 230V parameters are valid at 50Hz mains frequency.

may

A key word indicating flexibility of choice with no implied preference.

shall

A key word indicating a mandatory requirement.

should

A key word indicating flexibility of choice with a strongly preferred implementation.

Dec. 2014 / Rev. 2.2 DS-QS10.DNET-EN

All parameters are specified at 24V, 8A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

2/22