This document is proprietary. Any dispatch or disclosure of content is authorized only after written authorization by PULS GmbH.

All parameters are specified at 400V, 2.5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

Specification: SP-PAS395 Rev: 3.1

Date: 2013/01/19

4-14

4

Performance Description

4.1

Input

Input Voltage:

Turn-on Voltage

typ. 164Vac

Shut-down Voltage

typ. 151Vac

Input Current:

typ. 5.2A (at 230Vac and 1000W output power)

Input Frequency:

Power Factor:

> 0.9

Inrush Current:

< 10A peak (active limited, temperature independent)

4.2

Output

End-of-Charge Voltage:

Adjustable:

360-460Vdc (output voltage)

Factory setting: 410Vdc

OVP voltage:

370-470Vdc; auto setting (OVP = Output over-voltage protection)

The OVP voltage automatically adjusts to 10V higher then the end-

of-charge voltage after following the procedure for setting the end-

of-charge voltage.

Testing the OVP level: Tune the end-of charge-voltage

potentiometer clockwise until the “Fully Charged” LED starts

flashing. This indicates the OVP level.

Output Current:

min. 2.5A at 400Vdc end-of-charge voltage