T1508 datasheet(2/4 Pages) AMPHENOL

2 / 4 page

Calibration Kits

T2075NG and T2076NG

Calibration Process

The calibration is simple and can be done in just a few

minutes. Each CO2 model has a calibration process

similar to the following:

• Connect the tubing assembly to the sensor and

connect the regulator to the gas bottle.

• Initiate the calibration process by using the sensor

buttons and display.

• The process is automatically run by the sensor and

will signal upon completion.

• Last, disconnect the tubing and gas regulator.

T2075NG Components

The Calibration Kit Model T2075NG includes:

• Instruction sheet

• Tubing assembly

• Gas regulator with gauge

• Carrying case.

Calibrates the following models:

• Ventostat 8000 and 8100 Series

• Telaire 7000 Series

• Use in conjunction with UIP software for T8000 series

(T8100, T8200, T8300)

T2076NG Components

The Calibration Kit Model T2076NG includes:

• Instruction sheet

• Tubing assembly

• Gas regulator with gauge

• Carrying case.

• Flow Meter

Calibrates the following models:

• Vaporstat 9002

*Nitrogen gas not included.

Requires disposable gas tank: CGA600, 99.95%

Nitrogen 20 bar fill pressure, approximately one liter.

The illustration shows the complete set-up

for calibrating a sensor with display.

*Nitrogen gas not included.

Requires disposable gas tank: CGA600, 99.95%

Nitrogen 20 bar fill pressure, approximately one liter.

T1508 bảng dữ liệu(PDF) 2 Page - Amphenol Corporation