9

Patient Care Unit with Standard Laminate or Optional Terreon® Top

Installation Instructions

LC700, LC750

Bradley Corporation • 215-1171 Rev. D; EN 04-1037

8/16/04

Installation Instructions

continued . . .

Step 9: Reinstall and adjust the door linkage

1. Reinstall the door linkage by loosely fastening the door linkage rod with the supplied nut onto

the linkage bracket (see Figure 18).

2. Close the door. If the water closet contacts the back wall before the door closes, adjust the door

linkage by turning the door linkage rod so that the door closes before the water closet comes in

contact with the back wall (see Figure 18). If no adjustment is needed, tighten the nut securely

on the linkage bracket.

NOTE: The linkage arm has a factory-set length. When the door linkage is fastened to the linkage

bracket, the door will open 110 degrees. If the PATIENT CARE UNIT is installed against a corner

wall, make sure the door does not come in contact with the wall, or the water closet does not come in

contact with the back wall when the door is opened or closed. Make adjustments, if necessary, and

refer to Figure 18 with inset.

3. After the adjustments are made, tighten the nut securely on the linkage arm.

Figure 18

2nd hole for 110 °

opening

3rd hole for 90 °

opening

DOOR

LINKAGE

BRACKET

DOOR

LINKAGE

ARM