408-10022 datasheet(2/2 Pages) MACOM

2 / 2 page

408- 10022

Die Assembly 1804018- 1

Rev B

of 2

Tyco Electronics Corporation

5.1. Maintenance

1. Remove dust, moisture, and other contaminants

with a clean, soft brush, or a clean, soft, lint--free

cloth. DO NOT use any objects that could damage

the dies or tool.

2. Make sure that the retaining screws are properly

secured.

3. When the dies are not in use, store them in a

clean, dry area.

5.2. Inspection

1. Remove all lubrication and accumulated film

from the dies by immersing the dies in a suitable

commercial degreaser.

2. Make certain that all retaining screws and die

components are properly secured.

3. Inspect the crimping surfaces for flattened,

chipped, worn, or cracked areas. If damage is

evident, the dies must be replaced. Refer to

Section 8, REPLACEMENT.

5.3. Measuring the Die Opening

Measure the die opening to ensure that it meets the

dimensions given in Figure 2.

6. REPLACEMENT

Customer--replaceable parts are given in Figure 1.

A complete inventory should be stocked and

controlled to prevent lost time when replacement of

parts is necessary. Order replacement parts through

your representative, or call 1--800--526--5142, or send

a facsimile of your purchase order to 717--986--7605,

or write to:

CUSTOMER SERVICE (038--035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105--3608

Figure 2

9.40 +0.03

[.370+.001]

11.87 +0.03

[.466+.001]

Note:

Not to Scale

7. REVISION SUMMARY

Revisions to this instruction sheet include:

Updated instruction sheet to corporate

requirements

Removed obsolete product from Figure 1

Added installation of pins to Steps 2 and 3 of

Section 3

Modified Section 6

408-10022 bảng dữ liệu(PDF) 2 Page - Tyco Electronics

408-10022 bảng dữ liệu(HTML) 2 Page - Tyco Electronics

Html Pages

1 2

bảng dữ liệu tải về

Link URL