| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
M30LW128D bảng dữ liệu(PDF) 11 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
M30LW128D bảng dữ liệu(HTML) 11 Page - STMicroelectronics |
|
11 / 57 page ![]() 11/57 M30LW128D s Status - the pin gives a pulsing signal to indicate the end of a Program or Block Erase operation. After power-up or reset the STS pin is configured in Ready/Busy mode. The pin can be configured for Status mode using the Configure STS com- mand. When the Program/Erase Controller is idle, or sus- pended, STS can float High through a pull-up re- sistor. The use of an open-drain output allows the STS pins from several devices to be connected to a single pull-up resistor (a Low will indicate that one, or more, of the memories is busy). STS is not Low during a reset unless the reset was applied when the Program/Erase controller was active. The STS signal is not available with the LFBGA88 package. Program/Erase Enable (VPEN). The Program/ Erase Enable input, VPEN, is used to protect all blocks, preventing Program and Erase operations from affecting their data. Program/Erase Enable must be kept High during all Program/Erase Controller operations, other- wise the operations is not guaranteed to succeed and data may become corrupt. VDD Supply Voltage. VDD provides the power supply to the internal core of the device. It is the main power supply for all operations (Read, Pro- gram and Erase). VDDQ Supply Voltage. VDDQ provides the power supply to the I/O pins and enables all Outputs to be powered independently from VDD. VDDQ can be tied to VDD or can use a separate supply. It is recommended to power-up and power-down VDD and VDDQ together to avoid any condition that would result in data corruption. VSS Ground. Ground, VSS, is the reference for the core power supply. It must be connected to the system ground. VSSQ Ground. VSSQ ground is the reference for the input/output circuitry driven by VDDQ. VSSQ must be connected to VSS. Note: Each device in a system should have VDD and VDDQ decoupled with a 0.1µF ceramic capacitor close to the pin (high frequency, in- herently low inductance capacitors should be as close as possible to the package). See Fig- ure 10, AC Measurement Load Circuit. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |