MIC5202

DS20005614A-page 4

 2016 Microchip Technology Inc.

Enable Input

Enable Input Voltage

——

0.7

V

Logic-Low = Off

2.0

—

—

Logic-High = On

Enable Input Current

—0.01—

µA

—8

50

TABLE 1-1:

ELECTRICAL CHARACTERISTICS (CONTINUED)

Parameters

Sym.

Min.

Typ.

Max.

Units

Conditions

Note 1: Specification for packaged product only.

2: Output voltage temperature coefficient is defined as the worst case voltage change divided by the tem-

perature range.

3: Load regulation is measured at a constant junction temperature using low duty cycle pulse testing. Parts

are tested for load regulation in the load range from 0.1 mA to 100 mA. Changes in output voltage caused

by heating effects are covered by the thermal regulation specification.

4: Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its

nominal value measured at 1V differential.

5: Ground pin current is the regulator quiescent current plus pass transistor base current. The total current

drawn from the supply is the sum of the load current plus the ground pin current.

6: Thermal regulation is defined as the change in output voltage at a time “t” after a change in power dissipa-

tion is applied, excluding load or line regulation effects. Specifications are for a 100 mA load pulse at