DS2155 datasheet(56/262 Pages) DALLAS

56 / 262 page

DS2156

56 of 262

T1CCR1

T1 Common Control Register 1

07h

Bit #

Name

—

TRAI-CI

TAIS-CI

TFM

PDE

TLOOP

Default

Bit 0/Transmit Loop-Code Enable (TLOOP). See Section 25 for details.

0 = transmit data normally

1 = replace normal transmitted data with repeating code as defined in registers TCD1 and TCD2

Bit 1/Pulse Density Enforcer Enable (PDE). The framer always examines the transmit and receive data streams

for violations of these, which are required by ANSI T1.403: No more than 15 consecutive 0s and at least N 1s in

each and every time window of 8 x (N + 1) bits, where N = 1 through 23. Violations for the transmit and receive

data streams are reported in the INFO1.6 and INFO1.7 bits, respectively. When this bit is set to 1, the DS2156

forces the transmitted stream to meet this requirement no matter the content of the transmitted stream. When

running B8ZS, this bit should be set to 0 since B8ZS encoded data streams cannot violate the pulse density

requirements.

0 = disable transmit pulse density enforcer

1 = enable transmit pulse density enforcer

Bit 2/Transmit Frame Mode Select (TFM)

0 = D4 framing mode

1 = ESF framing mode

Bit 3/Transmit AIS-CI Enable (TAIS-CI). Setting this bit and the TBL bit (T1TCR1.1) causes the AIS-CI code

to be transmitted at TPOSO and TNEGO, as defined in ANSI T1.403.

0 = do not transmit the AIS-CI code

1 = transmit the AIS-CI code (T1TCR1.1 must also be set = 1)

Bit 4/Transmit RAI-CI Enable (TRAI-CI). Setting this bit causes the ESF RAI-CI code to be transmitted in the

FDL bit position.

0 = do not transmit the ESF RAI-CI code

1 = transmit the ESF RAI-CI code

Bits 5 to 7/Unused, must be set to 0 for proper operation

DS2155 bảng dữ liệu(PDF) 56 Page - Dallas Semiconductor