DSC400 datasheet(2/20 Pages) MICROCHIP

2 / 20 page

DSC400

DS20005612A-page 2

 2016 Microchip Technology Inc.

1.0

ELECTRICAL CHARACTERISTICS

Absolute Maximum Ratings †

Supply Voltage .......................................................................................................................................... –0.3V to +4.0V

Input Voltage .......................................................................................................................................–0.3V to VDD+0.3V

ESD Protection (HBM) ...............................................................................................................................................4 kV

ESD Protection (MM) ................................................................................................................................................400V

ESD Protection (CDM) ............................................................................................................................................1.5 kV

† Notice:

Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at those or any other conditions above those indicated

in the operational sections of this specification is not intended. Exposure to maximum rating conditions for extended

periods may affect device reliability.

ELECTRICAL CHARACTERISTICS

Specifications: VDD = 3.3V; TA = +25°C unless otherwise specified.

Parameters

Sym.

Min.

Typ.

Max.

Units

Conditions

Supply Voltage (Note 1)VDD

2.25

—

3.6

—

Core Supply Current (Note 2)IDDCORE

—

OE(1:2) = 0. All outputs

disabled.

Frequency Stability

∆f

—

±25

ppm

All temperature and VDD

ranges.

——

±50

Aging - First Year

∆fY1

—

±5

ppm

One year at +25°C

Aging - After First Year

∆fY2+

—

<±1

ppm/yr Year two and beyond at

+25°C

Start-up Time (Note 3)tSU

—

T = +25°C

Input Logic Levels

VIH

0.75 x VDD

—

Input logic high

VIL

—

0.25 x VDD

Input logic low

Output Disable Time (Note 4)tDA

—

OE(1:2) transition

from 1 to 0

Output Enable Time (Note 4)tEN

—

OE(1:2) transition

from 0 to 1

Pull-Up Resistor

RPU

—40

—

kΩ

All input pins have an

internal pull-up

Note 1:

VDD pins should be filtered with a 0.1 µF capacitor connected between VDD and VSS.

The addition of IDDCORE and IDDIO provides the total current consumption of the device.

tSU is time to 100 ppm stable output frequency after VDD is applied and outputs are enabled.

See the Output Waveform section for more information.

DSC400 bảng dữ liệu(PDF) 2 Page - Microchip Technology

DSC400 bảng dữ liệu(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

bảng dữ liệu tải về

Link URL