M45PE80 datasheet(19/36 Pages) STMICROELECTRONICS

19 / 36 page

19/36

M45PE80

Page Program (PP)

The Page Program (PP) instruction allows bytes to

be programmed in the memory (changing bits from

1 to 0, only). Before it can be accepted, a Write En-

able (WREN) instruction must previously have

been executed. After the Write Enable (WREN) in-

struction has been decoded, the device sets the

Write Enable Latch (WEL).

The Page Program (PP) instruction is entered by

driving Chip Select (S) Low, followed by the in-

struction code, three address bytes and at least

one data byte on Serial Data Input (D). If the 8

least significant address bits (A7-A0) are not all

zero, all transmitted data exceeding the ad-

dressed page boundary roll over, and are pro-

grammed from the start address of the same page

(the one whose 8 least significant address bits

(A7-A0) are all zero). Chip Select (S) must be driv-

en Low for the entire duration of the sequence.

The instruction sequence is shown in Figure 15..

If more than 256 bytes are sent to the device, pre-

viously latched data are discarded and the last 256

data bytes are guaranteed to be programmed cor-

rectly within the same page. If less than 256 Data

bytes are sent to device, they are correctly pro-

grammed at the requested addresses without hav-

ing any effects on the other bytes of the same

page.

Chip Select (S) must be driven High after the

eighth bit of the last data byte has been latched in,

otherwise the Page Program (PP) instruction is not

executed.

As soon as Chip Select (S) is driven High, the self-

timed Page Program cycle (whose duration is tPP)

is initiated. While the Page Program cycle is in

progress, the Status Register may be read to

check the value of the Write In Progress (WIP) bit.

The Write In Progress (WIP) bit is 1 during the self-

timed Page Program cycle, and is 0 when it is

completed. At some unspecified time before the

cycle is complete, the Write Enable Latch (WEL)

bit is reset.

A Page Program (PP) instruction applied

to a

page that is Hardware Protected is not executed.

Any Page Program (PP) instruction, while an

Erase, Program or Write cycle is in progress, is re-

jected without having any effects on the cycle that

is in progress.

Figure 15. Page Program (PP) Instruction Sequence

Note: 1. Address bits A23 to A20 are Don’t Care

2. 1

≤ n ≤ 256

AI04044

43 44 45 46 47 48 49 50

52 53 54 55

3456789 10

28 29 30 31 32 33 34 35

22 21

3210

36 37 38

Instruction

24-Bit Address

765432

Data Byte 1

765432

Data Byte 2

765432

Data Byte 3

Data Byte n

765432

MSB

M45PE80 bảng dữ liệu(PDF) 19 Page - STMicroelectronics

M45PE80 bảng dữ liệu(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

bảng dữ liệu tải về

Link URL