LPC2292 datasheet(21/40 Pages) PHILIPS

21 / 40 page

Philips Semiconductors

LPC2292/LPC2294

16/32-bit ARM microcontrollers with external memory interface

Preliminary data

Rev. 01 — 05 February 2004

21 of 40

9397 750 12748

6.14 UARTs

The LPC2292/LPC2294 each contain two UARTs. One UART provides a full modem

control handshake interface, the other provides only transmit and receive data lines.

6.14.1

Features

• 16 byte Receive and Transmit FIFOs.

• Register locations conform to ‘550 industry standard.

• Receiver FIFO trigger points at 1, 4, 8, and 14 bytes

• Built-in baud rate generator.

• Standard modem interface signals included on UART1.

6.15 I2C serial I/O controller

I2C is a bi-directional bus for inter-IC control using only two wires: a serial clock line

(SCL), and a serial data line (SDA). Each device is recognized by a unique address

and can operate as either a receiver-only device (e.g. an LCD driver or a transmitter

with the capability to both receive and send information (such as memory).

Transmitters and/or receivers can operate in either master or slave mode, depending

on whether the chip has to initiate a data transfer or is only addressed. I2C is a

multi-master bus, it can be controlled by more than one bus master connected to it.

I2C implemented in LPC2292/LPC2294 supports bit rate up to 400 kbit/s (Fast I2C).

6.15.1

Features

• Standard I2C compliant bus interface.

• Easy to conﬁgure as Master, Slave, or Master/Slave.

• Programmable clocks allow versatile rate control.

• Bidirectional data transfer between masters and slaves.

• Multi-master bus (no central master).

• Arbitration between simultaneously transmitting masters without corruption of

serial data on the bus.

• Serial clock synchronization allows devices with different bit rates to communicate

via one serial bus.

• Serial clock synchronization can be used as a handshake mechanism to suspend

and resume serial transfer.

• The I2C bus may be used for test and diagnostic purposes.

6.16 SPI serial I/O controller

The LPC2292/LPC2294 each contain two SPIs. The SPI is a full duplex serial

interface, designed to be able to handle multiple masters and slaves connected to a

given bus. Only a single master and a single slave can communicate on the interface

during a given data transfer. During a data transfer the master always sends a byte of

data to the slave, and the slave always sends a byte of data to the master.

LPC2292 bảng dữ liệu(PDF) 21 Page - NXP Semiconductors

LPC2292 bảng dữ liệu(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

bảng dữ liệu tải về

Link URL