| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
MCP2050T-E/P bảng dữ liệu(PDF) 11 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP2050T-E/P bảng dữ liệu(HTML) 11 Page - Microchip Technology |
|
11 / 40 page ![]() 2012-2014 Microchip Technology Inc. DS20002299C-page 11 MCP2050 1.4 Fail-Safe Features 1.4.1 GENERAL FAIL-SAFE FEATURES • An internal pull-down resistor on the CS/LWAKE pin disables the transmitter if the pin is floating. • An internal pull-up resistor on the TXD pin places TXD in high, thus the LBUS is recessive if the TXD pin is floating. • High-Impedance and low leakage current on LBUS during loss of power or ground. • The current limit on LBUS protects the transceiver from being damaged if the pin is shorted to VBB. 1.4.2 THERMAL PROTECTION The thermal protection circuit monitors the die temperature and is able to shut down the LIN transmitter and voltage regulator. There are three causes for a thermal overload. A thermal shut down can be triggered by any one, or a combination of, the following thermal overload conditions. • Voltage regulator overload • LIN bus output overload • Increase in die temperature due to increase in environment temperature The recovery time from the thermal shutdown is equal to adequate cooling time. Driving the TXD and checking the RXD pin makes it possible to determine whether there is a bus contention (TXD = high, RXD = low) or a thermal overload condition (TXD = low, RXD = high). FIGURE 1-7: THERMAL SHUTDOWN STATE DIAGRAMS 1.4.3 TXD/LBUS TIME-OUT TIMER LIN bus can be driven to a dominant level either from TXD pin or externally. An internal timer deactivates the LBUS transmitter if a dominant status (low) on LIN bus lasts longer than Bus Dominant Time-Out Time tTO(LIN) (approximately 20 ms); at the same time, RXD output is put in recessive (high), FAULT/TXE is also driven to low and the internal LIN pull-up resistor is disconnected. The timer is reset on any recessive LBUS status or POR mode. The recessive status on LBUS can be caused either by the bus being externally pulled up or by TXD pin being returned high. Operation Mode Transmitter Shutdown LIN bus Voltage Shutdown Regulator Output Temp < SHUTDOWNTEMP shorted to VBB Overload Temp < SHUTDOWN TEMP |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |