MCP23017-ESLASHML datasheet(25/42 Pages) MICROCHIP

25 / 42 page

 2005-2016 Microchip Technology Inc.

DS20001952C-page 25

MCP23017/MCP23S17

3.6.4

INTERRUPT OPERATION

The INTn interrupt output can be configured as

active-low, active-high or open-drain via the IOCON

Only those pins that are configured as an input (IODIR

(IOINTEN register) can cause an interrupt. Pins

defined as an output have no effect on the interrupt

output pin.

Input change activity on a port input pin that is enabled

for IOC generates an internal device interrupt and the

device captures the value of the port and copies it into

INTCAP. The interrupt remains active until the INTCAP

or GPIO register is read. Writing to these registers does

not affect the interrupt. The interrupt condition is

cleared after the LSb of the data is clocked out during

a read command of GPIO or INTCAP.

The first interrupt event causes the port contents to be

copied into the INTCAP register. Subsequent interrupt

conditions on the port will not cause an interrupt to

occur as long as the interrupt is not cleared by a read

of INTCAP or GPIO.

3.6.5

INTERRUPT CONDITIONS

There are two possible configurations that cause

interrupts (configured via INTCON):

Pins configured for interrupt-on-pin change

will cause an interrupt to occur if a pin changes

to the opposite state. The default state is reset

after an interrupt occurs and after clearing the

interrupt condition (i.e., after reading GPIO or

INTCAP). For example, an interrupt occurs by

an input changing from ‘1’ to ‘0’. The new initial

state for the pin is a logic ‘0’ after the interrupt is

cleared.

Pins configured for interrupt-on-change from

the corresponding input pin differs from the

long as the condition exists, regardless if the

INTCAP or GPIO is read.

See Figures 3-8 and 3-9 for more information on

interrupt operations.

FIGURE 3-8:

INTERRUPT-ON-PIN

CHANGE

FIGURE 3-9:

INTERRUPT-ON-CHANGE

FROM REGISTER

DEFAULT

Note:

The value in INTCAP can be lost if GPIO

is read before INTCAP while another IOC

is pending. After reading GPIO, the

interrupt will clear and then set due to the

pending

IOC,

causing

the

INTCAP

GPx

INT

ACTIVE

Port value

is captured

into INTCAP

Read GPIO

or INTCAP

Port value

is captured

into INTCAP

INT

Port value

is captured

into INTCAP

Read GPIO

or INTCAP

DEFVAL REGISTER

GP2

GPx<7:0>

ACTIVE

(INT clears only if interrupt

condition does not exist.)

MCP23017-E/ML bảng dữ liệu(PDF) 25 Page - Microchip Technology

MCP23017-E/ML bảng dữ liệu(HTML) 25 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

bảng dữ liệu tải về

Link URL