FDC37C669 datasheet(41/164 Pages) SMSC

41 / 164 page

COMMAND SET/DESCRIPTIONS

Commands can be written whenever the FDC is

in the command phase. Each command has a

unique set of needed parameters and status

results.

The FDC checks to see that the first

byte is a valid command and, if valid, proceeds

with the command. If it is invalid, an interrupt

is issued.

The user sends a Sense Interrupt

Status command which returns an invalid

command

error.

Refer

Table

explanations of the various symbols used.

Table 19 lists the required parameters and the

results associated with each command that the

FDC is capable of performing.

Table 18 - Description of Command Symbols

SYMBOL

NAME

DESCRIPTION

Cylinder Address

The currently selected address; 0 to 255.

Data Pattern

The pattern to be written in each sector data field during

formatting.

D0, D1, D2,

Drive Select 0-3

Designates

which

drives

are

perpendicular

drives

the

Perpendicular Mode Command. A "1" indicates a perpendicular

drive.

DIR

Direction Control

If this bit is 0, then the head will step out from the spindle during a

relative seek. If set to a 1, the head will step in toward the spindle.

DS0, DS1

Disk Drive Select

DS1

DS0

DRIVE

drive 0

drive 1

drive 2

drive 3

DTL

Special Sector

Size

By setting N to zero (00), DTL may be used to control the number

of bytes transferred in disk read/write commands. The sector size

(N = 0) is set to 128. If the actual sector (on the diskette) is larger

than DTL, the remainder of the actual sector is read but is not

passed to the host during read commands; during write

commands, the remainder of the actual sector is written with all

zero bytes.

The CRC check code is calculated with the actual

sector. When N is not zero, DTL has no meaning and should be

set to FF HEX.

Enable Count

When this bit is "1" the "DTL" parameter of the Verify command

becomes SC (number of sectors per track).

EFIFO

Enable FIFO

This active low bit when a 0, enables the FIFO. A "1" disables the

FIFO (default).

EIS

Enable Implied

Seek

When set, a seek operation will be performed before executing any

read or write command that requires the C parameter in the

command phase. A "0" disables the implied seek.

EOT

End of Track

The final sector number of the current track.

FDC37C669 bảng dữ liệu(PDF) 41 Page - SMSC Corporation

FDC37C669 bảng dữ liệu(HTML) 41 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL