LM87 datasheet(11/43 Pages) TI1

tên linh kiện	LM87

Giải thích chi tiết về linh kiện	Serial Interface System Hardware Monitor with Remote Diode Temperature Sensing

PDF	43 Pages

Scroll/Zoom	100%

nhà sản xuất	TI1 [Texas Instruments]

Trang chủ	http://www.ti.com

Logo

11 / 43 page

LM87

www.ti.com

SNAS034J – APRIL 2000 – REVISED MARCH 2013

When the LM87 is started, it cycles through each measurement in sequence, and it continuously loops through

the sequence approximately once every 0.4 s. Each measured value is compared to values stored in

WATCHDOG, or Hardware High Limit registers. When the measured value violates the programmed limit the

LM87 will set a corresponding Interrupt in the Interrupt Status Registers. The hardware Interrupt line INT# is fully

programmable with separate masking of each Interrupt source. In addition, the Configuration Register has a

control bit to enable or disable the hardware Interrupt. Another hardware Interrupt line available, THERM# is

used to signal temperature specific events. Having a dedicated interrupt for these conditions allows specific

actions to be taken for thermal events. This output is enabled by setting bit 2 of Configuration Register 1.

The Chassis Intrusion input is designed to accept an active high signal from an external circuit that activates and

latches when the case is removed from the computer.

INTERFACE

Figure 5. LM87 Register Structure

Submit Documentation Feedback

Product Folder Links: LM87

LM87 bảng dữ liệu(PDF) 11 Page - Texas Instruments