LM4917MTSLASHNOPB datasheet(14/25 Pages) TI1

14 / 25 page

LM4917

SNAS238G – AUGUST 2004 – REVISED MAY 2013

www.ti.com

The last step in this design is setting the amplifier's

−3db frequency bandwidth. To achieve the desired ±0.25dB

pass band magnitude variation limit, the low frequency response must extend to at lease one

−fifth the lower

bandwidth limit and the high frequency response must extend to at least five times the upper bandwidth limit. The

gain variation for both response limits is 0.17dB, well within the ±0.25dB desired limit. The results are

fL = 100Hz / 5 = 20Hz

(9)

and

fH = 20kHz x 5 = 100kHz

(10)

As stated in the External Components Description section, both Ri in conjunction with Ci, and RL, create first

order highpass filters. Thus to obtain the desired low frequency response of 100Hz within ±0.5dB, both poles

must be taken into consideration. The combination of two single order filters at the same frequency forms a

second order response. This results in a signal which is down 0.34dB at five times away from the single order

filter

−3dB point. Thus, a frequency of 20Hz is used in the following equations to ensure that the response is

better than 0.5dB down at 100Hz.

Ci ≥ 1 / (2π*20kΩ*20Hz) = 0.397µF; use 0.39µF

(11)

The high frequency pole is determined by the product of the desired high frequency pole, fH, and the closed-loop

gain, AV. With a closed-loop gain of 1.5 and fH = 100kHz, the resulting GBWP = 150kHz which is much smaller

than the LM4917's GBWP of 3MHz. This figure displays that if a designer has a need to design an amplifier with

a higher gain, the LM4917 can still be used without running into bandwidth limitations.

Submit Documentation Feedback

Product Folder Links: LM4917

LM4917MT/NOPB bảng dữ liệu(PDF) 14 Page - Texas Instruments