TAS5010

SLAS328 – SEPTEMBER 2001

9

www.ti.com

functional description (continued)

de-emphasis selection

De-emphasis selection is accomplished by using the DEM_SEL and DEM_EN pins. See Table 3 for

de-emphasis selection description.

Table 3. De-Emphasis Selection

DEM_SEL

DEM_EN

DESCRIPTION

0

0

De-emphasis disabled

0

1

De-emphasis enabled for Fs = 44.1 kHz

1

1

De-emphasis enabled for Fs = 48 kHz

1

0

Forbidden modey. Do not use.

error status reporting (VALID_L and VALID_R)

The following is a list of the error conditions that will cause the VALID_L and VALID_R pins to be asserted low:

When either of the above conditions is met, the VALID_L and VALID_R goes low and the PWM outputs go to

the hard mute state. If the error condition is removed, the TAS5010 is reinitialized and the VALID_L and VALID_R

pins are asserted high.

serial interface formats

The TAS5010 is compatible with eight different serial interfaces. Available interface options are IIS, right

justified, left justified, and DSP frame. Table 4 indicates how these options are selected using the MOD0, MOD1,

and MOD2 pins.

Table 4. Hardware Selection of Serial Audio Modes

MODE

MOD2 PIN

MOD1 PIN

MOD0 PIN

SERIAL INTERFACE SDIN

0

0

0

0

16 bit, MSB first; right justified

1

0

0

1

20 bit, MSB first; right justified

2

0

1

0

24 bit, MSB first; right justified

3

0

1

1

16 bit IIS

4

1

0

0

20 bit IIS

5

1

0

1

24 bit IIS

6

1

1

0

16 bit MSB first, left justified

7

1

1

1

16 bit DSP frame

The following figures illustrate the relationship between the SCLK, LRCLK and the serial data I/O for the different

interface protocols. Note that there are always 64 SCLKs per LRCLK. The nondata bits are padded with

binary 0s.