OL

CE

OUT

V

R

I

=

N

CE

L

R

C

t

@

´

P

PULLUP

L

R

C

t

@

´

LM111, LM211, LM311

www.ti.com

SLCS007I – SEPTEMBER 1973 – REVISED JUNE 2015

•

When both IN– and IN+ are both within the common-mode range:

–

If IN– is higher than IN+ and the offset voltage, the output is low and the output transistor is sinking

current

–

If IN– is lower than IN+ and the offset voltage, the output is high impedance and the output transistor is

not conducting

•

When IN– is higher than common mode and IN+ is within common mode, the output is low and the output

transistor is sinking current

•

When IN+ is higher than common mode and IN– is within common mode, the output is high impedance and

the output transistor is not conducting

•

When IN– and IN+ are both higher than common mode, the output is undefined

9.2.2.2 Minimum Overdrive Voltage

Overdrive voltage is the differential voltage produced between the positive and negative inputs of the comparator

comparator, with the response time decreasing with increasing overdrive. Figure 14 and Figure 15 show positive

and negative response times with respect to overdrive voltage.

9.2.2.3 Output and Drive Current

Output current is determined by the pullup resistance and pullup voltage. The output current produces a output

The output current can also effect the transient response.

9.2.2.4 Response Time

determine the transient response. Equation 1 approximates the positive response time. Equation 2 approximates

desired temperature, or by Equation 3.

(1)

(2)

where

•

•

(3)

Copyright © 1973–2015, Texas Instruments Incorporated

Submit Documentation Feedback

13

Product Folder Links: LM111 LM211 LM311