Assembly Information

 Connection with soldering wires on unmounted module: Do not pretin the solderpads but pretin the wires and solder for max 4 s at

300 °C. Allow solderpoints to completely cool down before the next soldering. Prevent shear- or peel forces.

 Soldering of wires with the module mounted on a heatsink: Pretin solderpads and wires and solder for max 3 s at 350 °C. Allow

solderpoints to completely cool down before the next soldering. Prevent shear- or peel forces.

 The smallest unit (100 mm- 5 LEDs) can be removed by cutting with scissors between the designated solder pads.

 The mounting of the module is facilitated by means of the double-sided adhesive on the back-surface of the module. Care must be tak

to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particle. The mounting substrate must have

sufficient structural integrity. Take care to completely remove the protective backing. Once the module is appropriately positioned, pre

on the module with about 20N/cm² (refer to application techniques of 3M adhesive transfer tapes). In difficult cases the use of a prime

may help.

 The minimum bending radius is 2 cm. The module may be bent over a smaller radius but only in regions of the circuit board containing

electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.

 The thermal length expansion coefficient of the modul is 17*10^-6cm/cm/K. When installing in environments with large variations in

temperature (e.g. outdoor applications) and operating length of more than 2 m, the use of metallic mounting surfaces is necessary.

Otherwise it is advisable to use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion coefficients.

Productgroup

Productname

EAN *

S-Unit *

Ordering Guide

LINEARlight Flex

LF05A-W3F-854

4008321546586

8

LINEARlight Flex

LF05A-W3F-840

4008321955364

8

LINEARlight Flex

LF05A-W3F-830

4008321955371

8

LINEARlight Flex

LF05A-W3F-827

4008321546906

8

LINEARlight Flex

LF05A-B3

4008321955388

8

EAN: Ordering number per single module

S-Unit: Modules per shipping unit

*)

Note: Typical performance data are subject to change without any further notice, particularly as LED technology evolves.

Related and Further Information

New creativity in lighting design

LED Modules for illuminated signs



138 W002 GB

The new dimension of light



153 S006 GB

www.osram.com/led-systems-downloads

OPTOTRONIC® Technical Guide



130 T008 GB www.osram.com/ecg-downloads

OPTOTRONIC® Data Sheets



http://catalog.myosram.com

OSRAM LED systems



www.osram.com/led-systems

New standards for LED control gear



130 W011 GB

www.osram.com/ecg-download

Sales and Technical Support

Sales and technical support is given by the

local OSRAM subsidiaries.

On our world wide homepage all OSRAM

subsidiaries are listed with complete

address and phone numbers.

OSRAM GmbH

Hellabrunner Strasse 1

D - 81536 München

Germany

www.osram.com

+49 (0)89 6213-0

Page 4 of 4

LF05A - 17.05.2010