PIC16F876ATISLASHML datasheet(121/234 Pages) MICROCHIP

121 / 234 page

 2003 Microchip Technology Inc.

DS39582B-page 119

PIC16F87XA

10.2.3

SETTING UP 9-BIT MODE WITH

ADDRESS DETECT

When setting up an Asynchronous Reception with

address detect enabled:

• Initialize the SPBRG register for the appropriate

baud rate. If a high-speed baud rate is desired,

set bit BRGH.

• Enable the asynchronous serial port by clearing

bit SYNC and setting bit SPEN.

• If interrupts are desired, then set enable bit RCIE.

• Set bit RX9 to enable 9-bit reception.

• Set ADDEN to enable address detect.

• Enable the reception by setting enable bit CREN.

• Flag bit RCIF will be set when reception is

complete, and an interrupt will be generated if

enable bit RCIE was set.

• Read the RCSTA register to get the ninth bit and

determine if any error occurred during reception.

• Read the 8-bit received data by reading the

RCREG register to determine if the device is

being addressed.

• If any error occurred, clear the error by clearing

enable bit CREN.

• If the device has been addressed, clear the

ADDEN bit to allow data bytes and address bytes

to be read into the receive buffer and interrupt the

CPU.

FIGURE 10-6:

USART RECEIVE BLOCK DIAGRAM

x64 Baud Rate CLK

SPBRG

Baud Rate Generator

RC7/RX/DT

Pin Buffer

and Control

SPEN

Data

Recovery

CREN

OERR

FERR

RSR Register

MSb

LSb

RX9D

RCREG Register

FIFO

Interrupt

RCIF

RCIE

Data Bus

÷ 64

÷ 16

Stop

Start

(8)

RX9

• • •

RX9

ADDEN

RX9

ADDEN

RSR<8>

Enable

Load of

Receive

Buffer

FOSC

PIC16F876ATI/ML bảng dữ liệu(PDF) 121 Page - Microchip Technology

PIC16F876ATI/ML bảng dữ liệu(HTML) 121 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL