TDA9116 datasheet(46/47 Pages) STMICROELECTRONICS

46 / 47 page

TDA9116

Revision follow-up

PRODUCT PREVIEW

September 2000

version 2.0

Document created from last version of TDA9113 with changes emphasized in red.

In internal schematics, Pin 11 copied from TDA9115.

November 23, 2000

version 2.0

correction in pages 11, 14, 17, 20: HPOS and HSIZE were described on 8 bits instead of 7.

page 34:the unused current source has been deleted

page 36, figure 14: text relative to int./ext. sawtooth has been deleted.

January 11, 2001

version 2.1

page 8: value for autosync frequency (4.5) ratio replaced by 4.28

April 10, 2001

version 2.2,

page 10: new values for VRefO: 7.65, 7.9, 8.2 (min, typ, max respectively)

Page 17: new values for VThrXRay: 7.65, 7.9, 8.2 (min, typ, max respectively)

April 18, 2001

version 2.2

page 14: VEW-BCor parameter: in test conditions, sadOE replaced by sadOF

PRELIMINARY DATA

July 13, 2001

version 3.0

Section 10.4.1 -right column"The higher its value,..." ---> "The lower its value"

Section 10.5 -."...at the vertical middle..." ---> "...in the vertical middle..."

Section 7.6 -EW DRIVE SECTION parameter "

∆VEW/VEW.∆V

HO", added [fmax].

and changed value to +20

Note 31: added: “VEW[fmax] is the value at conditionVHO>VHOThrfr”.

Section 10.4 - “stabilizing time” changed to “stabilization time” (twice)

Section 7.9 - : max values for vertical and horizontal moiré cancellers moved to typ. val-

ues

DATASHEET

October 11, 2001

version 4.0

Section 7.1 -added “Min. Typ. Max.” in Thermal Data table

Section 10.5 -.Replaced figure 13: EWOut output waveforms

TDA9116 bảng dữ liệu(PDF) 46 Page - STMicroelectronics