TLP7920,TLP7920F

3

8.

8.

8.

8. Absolute Maximum Ratings (Note) (Unless otherwise specified, T

Absolute Maximum Ratings (Note) (Unless otherwise specified, T

Absolute Maximum Ratings (Note) (Unless otherwise specified, T

= 25

= 25

= 25 





))))

Characteristics

Supply Voltages

Steady-state input voltages

Two-second transient input voltages

Output voltages

Operating temperature

Storage temperature

Lead soldering temperature

Isolation voltage

(10 s)

AC, 60 s, R.H. ≤ 60 %

Symbol

Note

(Note 1)

(Note 2)

Rating

-0.5 to 6

-0.5 to 6

-6 to 6

-0.5 to 6

-40 to 105

-55 to 125

260

5000

Unit

V



Vrms

Note:

Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test

report and estimated failure rate, etc).

Note:

Ceramic capacitors (0.1 µF) should be connected between 1 and 4 pins and between 5 and 8 pins to stabilize

the operation. Otherwise, this photocoupler may not switch properly. The bypass capacitors should be placed

as close as possible to each pin.

Note 1: ≥ 2 mm below seating plane.

Note 2: This device is considered as a two-terminal device: Pins 1, 2, 3 and 4 are shorted together, and pins 5, 6, 7

and 8 are shorted together.

9.

9.

9.

9. Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Characteristics

Input side supply voltage

Output side supply voltage

Analog input voltage

Ambient temperature

Symbol

Note

(Note 1),

(Note 2)

Min

4.5

3.0

-200

-40

Typ.

5







Max

5.5

5.5

200

105

Unit

V

mV



Note:

The recommended operating conditions are given as a design guide necessary to obtain the intended

performance of the device. Each parameter is an independent value. When creating a system design using

this device, the electrical characteristics specified in this datasheet should also be considered.

Note 1: FSR = ±300 mV

2015-09-10

Rev.1.0

©2015 Toshiba Corporation