GS2971 datasheet(13/148 Pages) SEMTECH

13 / 148 page

GS2971 3Gb/s, HD, SD SDI Receiver

Data Sheet

45898 - 2

September 2012

13 of 148

SDIN_TDI

Input

COMMUNICATION SIGNAL INPUT

Please refer to the Input Logic parameters in the DC Electrical

Characteristics table for logic level threshold and compatibility.

GSPI serial data in/test data in.

In JTAG mode (JTAG/HOST = HIGH), this pin is used to shift test data

into the device.

In host interface mode, this pin is used to write address and

configuration data words into the device.

F1, G1AGCP, AGCNAutomatic Gain Control for the equalizer. Attach the AGC capacitor

between these pins.

CS_TMS

Input

COMMUNICATION SIGNAL INPUT

Please refer to the Input Logic parameters in the DC Electrical

Characteristics table for logic level threshold and compatibility.

Chip select / test mode start.

In JTAG mode (JTAG/HOST = HIGH), this pin is Test Mode Start, used

to control the operation of the JTAG test.

In host interface mode (JTAG/HOST = LOW), this pin operates as the

host interface chip select and is active LOW.

SCLK_TCK

Input

COMMUNICATION SIGNAL INPUT

Please refer to the Input Logic parameters in the DC Electrical

Characteristics table for logic level threshold and compatibility.

Serial data clock signal.

In JTAG mode (JTAG/HOST = HIGH), this pin is the JTAG clock.

In host interface mode (JTAG/HOST = LOW), this pin is the host

interface serial bit clock.

All JTAG/host interface addresses and data are shifted into/out of

the device synchronously with this clock.

F9, F10, H9,

H10, J8, J9,

J10, K8, K9,

K10

DOUT8, 9, 6, 7, 1,

4, 5, 0, 2, 3

Output

PARALLEL DATA BUS

Please refer to the Output Logic parameters in the DC Electrical

Characteristics table for logic level threshold and compatibility.

20-bit mode

20bit/10bit = HIGH

SMPTE mode (SMPTE_BYPASS = HIGH

and DVB_ASI = LOW):

Chroma data output for SD and HD

data rates; Data Stream 2 for 3G data

rate

DVB-ASI mode (SMPTE_BYPASS = LOW

and DVB_ASI = HIGH):

Not defined

Data-Through mode (SMPTE_BYPASS =

LOW and DVB_ASI = LOW):

Data output

10-bit mode

20bit/10bit = LOW

Forced LOW

Table 1-1: Pin Descriptions (Continued)

Number

Name

Timing

Type

Description

GS2971 bảng dữ liệu(PDF) 13 Page - Semtech Corporation

GS2971 bảng dữ liệu(HTML) 13 Page - Semtech Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL