VL6180X datasheet(14/79 Pages) STMICROELECTRONICS

14 / 79 page

Functional description

VL6180X

14/79

DocID026171 Rev 6

2.2

Timing diagram

Figure 9 and Table 4.show the Root part number 1 power-up timing constraints.

•

AVDD_VCSEL must be applied before or at the same time as AVDD.

•

GPIO0 defaults to an active low shutdown input. When GPIO0 = 0, the device is in

hardware standby. If GPIO0 is not used it should be connected to AVDD.

•

The internal microprocessor (MCU) boot sequence commences when AVDD is up and

GPIO0 is high whichever is the later.

•

GPIO1 power-up default is output low. It is tri-stated during the MCU boot sequence.

Note:

In hardware standby, GPIO1 is output low and will sink current through any pull-up resistor.

This leakage can be minimized by increasing the value of the pull-up resistor.

•

After the MCU boot sequence the device enters software standby. The software

standby state can be determined by polling

SYSTEM__FRESH_OUT_OF_RESET{0x16}

. Host initialization can commence

immediately after entering software standby.

Figure 9. Power-up timing

Table 4. Power-up timing constraints

Symbol

Parameter

Min

Max

Unit

AVDD_VCSEL power applied after AVDD

Minimum reset on GPIO0

100

GPIO1 output low after hardware standby

400

μs

MCU boot

Software standby to host initialization

AVDD

AVDD_VCSEL

GPIO0 (optional)

GPIO1

System state

fresh_out_of_reset

hardware

standby

hardware

standby

software

standby

mcu boot

software

standby

I2C Comms

mcu boot

VL6180X bảng dữ liệu(PDF) 14 Page - STMicroelectronics

VL6180X bảng dữ liệu(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

bảng dữ liệu tải về

Link URL