| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
USB3503 bảng dữ liệu(PDF) 13 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
USB3503 bảng dữ liệu(HTML) 13 Page - Microchip Technology |
|
13 / 73 page ![]() 2011-2015 Microchip Technology Inc. DS00001584B-page 13 USB3503 TABLE 3-4: USB3503 SECONDARY REFERENCE CLOCK FREQUENCIES 3.3.4 INTERRUPT The general interrupt pin (INT_N) is intended to communicate a condition change within the hub. The conditions that may cause an interrupt are captured within a register mapped to the serial port (Register E8h: Serial Port Interrupt Status - INT_STATUS). The conditions that cause the interrupt to assert can be controlled through use of an interrupt mask register (Register E9h: Serial Port Interrupt Mask - INT_MASK). The general interrupt and all interrupt conditions are functionally latched and event driven. Once the interrupt or any of the conditions have asserted, the status bit will remain asserted until the SOC negates the bit using the serial port. The bits will then remain negated until a new event condition occurs. The latching nature of the register causes the status to remain even if the condition that caused the interrupt ceases to be active. The event driven nature of the register causes the interrupt to only occur when a new event occurs- when a condition is removed and then is applied again. The function of the interrupt and the associated status and masking registers are illustrated in Figure 3-3. Registers & Register bits shown in the figure are defined in Table 5-2, “Serial Interface Registers,” on page 19. TABLE 3-3: USB3503 PRIMARY REFERENCE CLOCK FREQUENCIES REF_SEL[1:0] Frequency (MHz) ‘00’ 38.4 ‘01’ 26.0 ‘10’ 19.2 ‘11’ 12.0 REF_SEL[1:0] Frequency (MHz) ‘00’ 24.0 ‘01’ 27.0 ‘10’ 25.0 ‘11’ 50.0 FIGURE 3-3: INT_N OPERATION Reserved Reserved Serial Port Write Logic INT_N Q Q SET CLR D INT_MASK <1> <2> <3> <4> Q Q SET CLR S R INT_STATUS <7> <0> Q Q SET CLR S R Q Q SET CLR S R Q Q SET CLR S R Q Q SET CLR S R Q Q SET CLR S R INT_STATUS<4:0> SCL/SDA Hub Configured by USB Host (HubConf) Port Power Register Updated (PrtPwr) Hub in USB Suspend Mode (SuspInd) Suspended OR NOT Configured Q Q SET CLR D CFGP.INTSUSP |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |