SMARTRF06 datasheet(21/45 Pages) TI

21 / 45 page

User’s Guide

SWRU321A

– May 2013

Page 21/32

6.9 LEDs

6.9.1 General Purpose LEDs

The four LEDs D601, D602, D603, D604 can be controlled from the mounted EM and are suitable

for demo use and debugging. The LEDs are active high. Table 11 shows an overview of I/O

signals related to the LEDs.

Signal name

Description

Probe header

EM pin

LV_LED_1

LED 1 (red)

RF2.11 (P407.10)

RF2.11

LV_LED_2

LED 2 (yellow)

RF2.13 (P411.2)

RF2.13

LV_LED_3

LED 3 (green)

RF1.2 (P406.1)

RF1.2

LV_LED_4

LED 4 (red-orange)

RF1.4 (P406.2)

RF1.4

Table 11

– General purpose LED signal connections

6.9.2 XDS100v3 Emulator LEDs

The XDS100v3 emulator has two LEDs to indicate its status, D2 and D4. The LEDs are located

on the top side of the SmartRF06EB. LED D2 is lit whenever the XDS100v3 Emulator is powered,

while LED D4 (ADVANCED MODE) is lit when the XDS100v3 is in an active cJTAG debug state.

6.10 EM Connectors

The EM connectors, shown in Figure 15, are used for connecting an EM board to the

SmartRF06EB. The connectors RF1 and RF2 are the main interface and are designed to inhibit

incorrect mounting of the EM board. The pin-out of the EM connectors is given in Table 12 and

Table 13.

Figure 15

– SmartRF06EB EM connectors RF1 and RF2

SMARTRF06 bảng dữ liệu(PDF) 21 Page - Texas Instruments

SMARTRF06 bảng dữ liệu(HTML) 21 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

bảng dữ liệu tải về

Link URL