ISO5451 datasheet(16/38 Pages) TI

16 / 38 page

ISO5451

SLLSEO1B – JUNE 2015 – REVISED DECEMBER 2015

www.ti.com

9.3 Feature Description

9.3.1 Supply and active Miller clamp

The ISO5451 supports both bipolar and unipolar power supply with active Miller clamp.

For operation with bipolar supplies, the IGBT is turned off with a negative voltage on its gate with respect to its

emitter. This prevents the IGBT from unintentionally turning on because of current induced from its collector to its

gate due to Miller effect. In this condition it is not necessary to connect CLAMP output of the gate driver to the

IGBT gate. Typical values of VCC2 and VEE2 for bipolar operation are 15 V and -8 V with respect to GND2.

For operation with unipolar supply, typically, VCC2 is connected to 15 V with respect to GND2, and VEE2 is

connected to GND2. In this use case, the IGBT can turn-on due to additional charge from IGBT Miller

capacitance caused by a high voltage slew rate transition on the IGBT collector. To prevent IGBT to turn on, the

CLAMP pin is connected to IGBT gate and Miller current is sinked through a low impedance CLAMP transistor.

Miller CLAMP is designed for miller current up to 2 A. When the IGBT is turned-off and the gate voltage

transitions below 2 V the CLAMP current output is activated.

9.3.2 Active Output Pull-down

The Active output pull-down feature ensures that the IGBT gate OUT is clamped to VEE2 to ensure safe IGBT off-

state when the output side is not connected to the power supply.

9.3.3 Undervoltage Lockout (UVLO) with Ready (RDY) Pin Indication Output

Undervoltage Lockout (UVLO) ensures correct switching of IGBT. The IGBT is turned-off, if the supply VCC1

drops below VIT-(UVLO1), irrespective of IN+, IN- and RST input till VCC1 goes above VIT+(UVLO1).

In similar manner, the IGBT is turned-off, if the supply VCC2 drops below VIT-(UVLO2), irrespective of IN+, IN- and

RST input till VCC2 goes above VIT+(UVLO2).

Ready (RDY) pin indicates status of input and output side Under Voltage Lock-Out (UVLO) internal protection

feature. If either side of device have insufficient supply (VCC1 or VCC2), the RDY pin output goes low; otherwise,

RDY pin also serves as an indication to the micro-controller that the device is ready for operation.

9.3.4 Fault (FLT) and Reset (RST)

During IGBT overload condition, to report desaturation error FLT goes low. If RST is held low for the specified

duration, FLT is cleared at rising edge of RST. RST has an internal filter to reject noise and glitches. By asserting

RST for at-least the specified minimum duration, device input logic can be enabled or disabled.

9.3.5 Short Circuit Clamp

Under short circuit events it is possible that currents are induced back into the gate-driver OUT and CLAMP pins

due to parasitic Miller capacitance between the IGBT collector and gate terminals. Internal protection diodes on

OUT and CLAMP help to sink these currents while clamping the voltages on these pins to values slightly higher

than the output side supply.

Submit Documentation Feedback

Product Folder Links: ISO5451

ISO5451 bảng dữ liệu(PDF) 16 Page - Texas Instruments