SP5611KGMPAS datasheet(10/12 Pages) MITEL

tên linh kiện	SP5611KGMPAS

Giải thích chi tiết về linh kiện	1쨌3GHz Bidirectional I2C Bus Controlled Synthesiser

PDF	12 Pages

Scroll/Zoom	100%

nhà sản xuất	MITEL [Mitel Networks Corporation]

Trang chủ	http://www.mitel.com

Logo

10 / 12 page

SP5611

Normal operation, reference divider ratio = 1024

Normal operation, reference divider ratio = 512

Charge pump source (down), FL set to 0

Charge pump sink (up), FL set to 1

Port P7 = FPD/2

Port P7 = FPD, P6 = FCOMP

Charge pump disable, reference divider ratio = 512

Varactor line disable, reference divider ratio = 512

Charge pump and varactor linedisable, reference divider ratio = 512

Operation mode description

Table 5 Operation modes

Hex code (byte 4)

CP high mode

CP low mode

TEST MODES

As explained in the functional description, The SP5611 can

be programmed into a numb er of test modes. These are invoked

by programming Hex codes into byte 4, those most commonly

used being shown in Table 6.

Other codes will also apply due to don’t care conditions, which

are assumed to be 1 in the Table.

NOTE:

When looking at FPD or FCOMP signals from ports P7 and P6. byte

should be sent twice, first to set the desired reference division

ratio then to switch on the chosen test mode.

The pulses can then be measured by simply connecting an

oscilloscope or counter to the relevant output pin on thetest board.

SP5611KGMPAS bảng dữ liệu(PDF) 10 Page - Mitel Networks Corporation