LP3883 datasheet(11/19 Pages) TI

11 / 19 page

LP3883

www.ti.com

SNVS223F – NOVEMBER 2002 – REVISED APRIL 2013

θJA = TRmax / PD

(6)

These parts are available in TO-220 and DDPAK/TO-263 packages. The thermal resistance depends on amount

of copper area or heat sink, and on air flow. If the maximum allowable value of

θJA calculated above is ≥ 60 °C/W

for TO-220 package and

≥ 60 °C/W for DDPAK/TO-263 package no heatsink is needed since the package can

dissipate enough heat to satisfy these requirements. If the value for allowable

θJA falls below these limits, a heat

sink is required.

HEATSINKING TO-220 PACKAGE

The thermal resistance of a TO220 package can be reduced by attaching it to a heat sink or a copper plane on a

PC board. If a copper plane is to be used, the values of

θJA will be same as shown in next section for TO263

package.

The heatsink to be used in the application should have a heatsink to ambient thermal resistance,

θHA≤ θJA − θCH − θJC.

(7)

In this equation,

θCH is the thermal resistance from the case to the surface of the heat sink and θJC is the thermal

resistance from the junction to the surface of the case.

θJC is about 3°C/W for a TO220 package. The value for

θCH depends on method of attachment, insulator, etc. θCH varies between 1.5°C/W to 2.5°C/W. If the exact value

is unknown, 2°C/W can be assumed.

HEATSINKING DDPAK/TO-263 PACKAGE

The DDPAK/TO-263 package uses the copper plane on the PCB as a heatsink. The tab of these packages are

soldered to the copper plane for heat sinking. The graph below shows a curve for the

θJA of DDPAK/TO-263

package for different copper area sizes, using a typical PCB with 1 ounce copper and no solder mask over the

copper area for heat sinking.

Figure 34.

θJA vs Copper (1 Ounce) Area for DDPAK/TO-263 package

As shown in the graph below, increasing the copper area beyond 1 square inch produces very little improvement.

The minimum value for

θJA for the DDPAK/TO-263 package mounted to a PCB is 32°C/W.

Figure 35 shows the maximum allowable power dissipation for DDPAK/TO-263 packages for different ambient

temperatures, assuming

θJA is 35°C/W and the maximum junction temperature is 125°C.

Figure 35. Maximum power dissipation vs ambient temperature for DDPAK/TO-263 package

Submit Documentation Feedback

Product Folder Links: LP3883

LP3883 bảng dữ liệu(PDF) 11 Page - Texas Instruments

LP3883 bảng dữ liệu(HTML) 11 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

bảng dữ liệu tải về

Link URL