622Mbps, 3.3V Clock-Recovery and

Data-Retiming IC with Limiting Amplifier

______________________________________________________________________________________

13

allowable pattern-dependent jitter, peak-to-peak

(seconds); and BW = typical system bandwidth, nor-

mally 0.6 to 1.0 times the data rate (Hertz). If the PDJ is

still larger than desired, continue increasing the value of

MAX3676 analog inputs (ADI+, ADI-), it is important to

(Table 1).

PDJ can also be present due to insufficient high-fre-

quency bandwidth (Figure 10). If the amplifiers are not

fast enough to allow for complete transitions during sin-

gle-bit patterns, or if the amplifier does not allow ade-

quate settling time, high-frequency PDJ can result.

Pulse-Width Distortion

Finally, PWD occurs when the midpoint crossing of a

0–1 transition and a 1–0 transition does not occur at the

same level (Figure 11). DC offsets and nonsymmetrical

rising and falling edge speeds both contribute to PWD.

For a 1–0 bit stream, calculate PWD as follows:

PWD = [(width of wider pulse) -

(width of narrower pulse)] / 2

Phase Adjust

The internal clock and data alignment in the MAX3676

is well maintained close to the center of the data eye.

Although not required, this sampling point can be shift-

ed using the PHADJ inputs to optimize BER perfor-

mance. The PHADJ inputs operate with differential

input signals to approximately ±1V. A simple resistor

divider with a bypass capacitor is sufficient to set up

these levels. When the PHADJ inputs are not used, they

Figure 10. Pattern-Dependent Jitter Due to High-Frequency

Rolloff

TIME

MIDPOINT

LONG

CONSECUTIVE

BIT STREAM

0-1-0 BIT STREAM

HF PDJ

Figure 11. Pulse-Width Distortion

TIME

MIDPOINT

WIDTH OF A ONE

WIDTH OF A ZERO

PWD RESULTS WHEN THE WIDTH

OF A ZERO DOES NOT EQUAL

THE WIDTH OF A ONE.