LTC1450CG datasheet(9/16 Pages) LINER

9 / 16 page

LTC1450/LTC1450L

DAC CODE

1450/50L • F01

OUTPUT

VOLTAGE

NEGATIVE

OFFSET

Figure 1. Effect of Negative Offset

Integral Nonlinearity (INL): End-point INL is the maxi-

mum deviation from a straight line passing through the

end points of the DAC transfer curve. Because the part

operates from a single supply and the output cannot go

below zero, the linearity is measured between full scale

and the code corresponding to the maximum offset

specification. The INL error at a given input code is

calculated as follows:

INL

= [VOUT – VOS – (VFS – VOS)(code/4095)]/LSB

VOUT = The output voltage of the DAC measured at

the given input code

Differential Nonlinearity (DNL): DNL is the difference

between the measured change and the ideal one LSB

change between any two adjacent codes. The DNL error

between any two codes is calculated as follows:

DNL

= (

∆VOUT – LSB)/LSB

∆VOUT = The measured voltage difference between

two adjacent codes

Digital Feedthrough: The glitch that appears at the analog

output caused by AC coupling from the digital inputs when

they change state. The area of the glitch is specified in

(nV)

(s).

Resolution (n): Resolution is defined as the number of

digital input bits (n). It defines the number of DAC output

states (2n) that divide the full-scale range. The resolution

does not imply linearity.

Full-Scale Voltage (VFS): This is the output of the DAC

when all bits are set to 1.

Voltage Offset Error (VOS): The theoretical voltage at the

output when the DAC is loaded with all zeros. The output

amplifier can have a true negative offset, but because the

part is operated from a single supply, the output cannot go

below zero. If the offset is negative, the output will remain

near 0V resulting in the transfer curve shown in Figure 1.

The offset of the part is measured at the code that corre-

sponds to the maximum offset specification:

VOS = VOUT – [(Code)(VFS)/(2

n – 1)]

Least Significant Bit (LSB): One LSB is the ideal voltage

difference between two successive codes.

LSB = (VFS – VOS)/(2n – 1) = (VFS – VOS)/4095

Nominal LSBs:

LTC1450

LSB = 4.095V/4095 = 1mV

LTC1450L

LSB = 2.5V/4095 = 0.610mV

DEFI ITIO S

LTC1450CG bảng dữ liệu(PDF) 9 Page - Linear Technology

LTC1450CG bảng dữ liệu(HTML) 9 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

bảng dữ liệu tải về

Link URL