OLS2 Series

Optical liquid level sensor M12 mount

www.cynergy3.com

© 2012 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.

ISO

Cynergy3 Components Ltd.

7 Cobham Road

Ferndown Industrial Estate

Wimborne, Dorset BH21 7PE

Telephone +44 (0) 1202 897969

Email:sales@cynergy3.com

Installation

The sensor can be mounted in either the side or the bottom of a tank. It must not be mounted in the top of a tank with

the cone downwards.

This sensor requires a hole of 12mm minimum or an M12x1 thread socket connection. The hole should be in a flat

surface and be free of burrs.

The sensor with suitable gasket should be inserted into the hole and a fixing nut fitted on the M12 thread on the inside

of the tank. Alternatively the sensor can be screwed into a M12x1 socket. The sensor should not be overtightened.

Cleaning

Proper fluids should be selected based on the type of contamination to be removed. It is recommended that freon or

alcohol based solvents are used.

DO NOT USE chlorinated solvents such as trichloroethylene as these are likely to attack the sensor housing material.

Liquid Media Compatibility

Check that the fluid in which you wish to use the sensor is compatible with Polysulfone.

Red wire =Vs

“O” ring gasket

Fixing nut M12x1

Green wire =Output

Output version 003 N-Channel Open Drain

Blue wire = 0V

Load

V+

Din

to rest of sensor circuit

O/P

O/P