5

ICS9147-16

Recommended PCB Layout for ICS9147-16

NOTE:

This PCB Layout is based on a 4 layer board with an internal Ground (common) and Vcc plane. Placement of

components will depend on routing of signal trace. The 0.1uf Capacitors should be placed as close as possible

to the Power pins. Placement on the backside of the board is also possible. The Ferrite Beads can be replaced

with 10-15ohm Resistors. For best results, use a Fixed Voltage Regulator between the main (board) Vcc and the

different Vdd planes.