CPU-1452

Celeron 400MHz Fanless SBC with 4x USB 2.0 and 4x USB 1.1 ports (RoHS)

Eurotech S.p.A.

e-mail: sales@eurotech.it

http://www.eurotech.it

ETH_CPU-1452_DS131206

Features

Architecture:

PC/104-Plus compliant

Processor:

Intel® Celeron® 400MHz, 256KB L2 cache, 100MHz FSB

Chipset:

Intel® 815E

Memory:

256MB SDRAM soldered onboard

Supported Operating Systems:

WinCE®, WinXPE® and Linux®

BIOS Flash:

1MB Flash EPROM

Interfaces:

•

IDE Controller Ultra DMA

•

Serial ports:

−

−

−

−

−

−

1x RS-232

1x RS-232/422/485

•

USB ports:

4x USB 1.1

4x USB 2.0

•

10/100 Mbps Ethernet (Intel® 82562ET chipset)

•

Video Controllers:

Analog VGA output

Digital LVDS output

•

Auxiliary Power

•

AC97

•

Keyboard and Mouse

Bus:

•

PC/104-Plus (PCI)

•

PC/104 (ISA)

Watchdog:

2-255 seconds / minutes

Power Supply:

Single +5V DC

RoHS

General Description

The CPU-1452 is an embedded RoHS compliant board based on two modules: a mezzanine CPU module combined with a PC/104-Plus form factor

carrier.

The mezzanine CPU module features the processor and its Intel® 815E chipset with 100MHz bus frequency. The processor is the Intel®

Celeron® 400MHz. The system comes with 256MB SDRAM soldered onboard. No active cooling is required to operate within the standard and

extended temperature ranges. The carrier implements all the connections to the external world, including 8 USB ports (4x USB 1.1 and 4x USB

2.0), 1 Fast Ethernet interface (10/100Mbps), 2 Serial ports, Analog VGA and Digital LVDS outputs, 1 AC97 interface, Auxiliary Power, Keyboard

and Mouse connectors and an IDE controller that supports any type of IDE Flash device (Disk-On-Module, Compact Flash and Flash Disk). The

carrier also performs the connections for the ISA and PCI bus enabling the CPU-1452 to stack on top of a PC/104-Plus system. The carrier

provides support for Watchdog management and Real Time Clock (external backup battery) and can be customized to match specific customer

needs.

The BIOS for the module is embedded and is located in a 1MB Flash EPROM, it is fully re-programmable onboard. The set-up parameters are

saved in Flash to allow the module to operate without a battery.