VND830ASP-E datasheet(17/27 Pages) STMICROELECTRONICS

17 / 27 page

VND830ASP-E

Application information

Doc ID 17605 Rev 2

17/27

Application information

Figure 19. Application schematic

3.1

GND protection network against reverse battery

3.1.1

Solution 1: resistor in the ground line (RGND only)

This can be used with any type of load.

The following is an indication on how to dimension the RGND resistor.

RGND ≤ 600 mV / IS(on)max

RGND ≥ (-VCC) / (-IGND)

where -IGND is the DC reverse ground pin current and can be found in the absolute

maximum rating section of the device’s datasheet.

Power dissipation in RGND (when VCC < 0: during reverse battery situations) is:

PD= (-VCC)

2/ R

GND

This resistor can be shared amongst several different HSDs. Please note that the value of

this resistor should be calculated with formula (1) where IS(on)max becomes the sum of the

maximum on-state currents of the different devices.

Please note that if the microprocessor ground is not shared by the device ground then the

RGND produces a shift (IS(on)max * RGND) in the input thresholds and the status output

values. This shift varies depending on how many devices are ON in the case of several

high-side drivers sharing the same RGND.

If the calculated power dissipation leads to a large resistor or several devices have to share

the same resistor then ST suggests to utilize solution 2 (see Section 3.1.2).

VCC

GND

OUTPUT2

CURRENT SENSE1

Dld

+5V

Rprot

RSENSE2

OUTPUT1

RSENSE1

INPUT1

DGND

RGND

VGND

CURRENT SENSE2

INPUT2

μC

Rprot

VND830ASP-E bảng dữ liệu(PDF) 17 Page - STMicroelectronics

VND830ASP-E bảng dữ liệu(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27

bảng dữ liệu tải về

Link URL