ADS54RF63IPFPR datasheet(32/49 Pages) TI1

32 / 49 page

Clock Amplitude − VP−P

fS = 500 MSPS

fIN = 100 MHz

fIN = 300 MHz

G022

Clock Amplitude − VP−P

62.5

63.0

63.5

64.0

64.5

65.0

65.5

66.0

fIN = 100 MHz

fIN = 300 MHz

fS = 500 MSPS

G023

CLK

ADS5463

CLK

0.1

Clock

Source

S0194-02

ADS5463

ADS54RF63

SLAS515E – NOVEMBER 2006 – REVISED JULY 2009 ................................................................................................................................................... www.ti.com

Figure 59. ADS5463 SFDR versus Differential Clock

Figure 60. ADS5463 SNR versus Differential Clock Level

Level

The characterization of the ADS5463/ADS54RF63 is typically performed with a 3-VPP differential clock, but the

ADC performs well with a differential clock amplitude down to ~0.5 VPP (250-mV swing on both CLK and CLK),

as shown in Figure 59 and Figure 60. For jitter-sensitive applications, the use of a differential clock has some

advantages at the system level. The differential clock allows for common-mode noise rejection at the printed

circuit board (PCB) level. With a differential clock, the signal-to-noise ratio of the ADC is better for jitter-sensitive,

high-frequency applications because the board level clock jitter is superior.

Larger clock amplitude levels are recommended for high analog input frequencies or slow clock frequencies. At

high analog input frequencies, the sampling process is sensitive to jitter. At slow clock frequencies, a small

amplitude sinusoidal clock has a lower slew rate and can create jitter-related SNR degradation due to the

uncertainty in the sampling point associated with a slow slew rate. Figure 61 demonstrates a recommended

method for converting a single-ended clock source into a differential clock; it is similar to the configuration found

on the evaluation board and was used for much of the characterization. See also Clocking High Speed Data

Converters (SLYT075) for more details.

Figure 61. Differential Clock

The common-mode voltage of the clock inputs is set internally to 2.4 V using internal 1-k

Ω resistors (see

Figure 57). It is recommended to use ac coupling, but if this scheme is not possible, the ADS5463 features good

tolerance to clock common-mode variation, as shown in Figure 62 and Figure 63 (the ADS54RF63 behaves

similarly). The internal ADC core uses both edges of the clock for the conversion process. Ideally, a 50%

duty-cycle clock signal should be provided, though even 40/60 is good enough for many applications.

Performance degradation as a result of duty cycle can be seen in Figure 64.

Submit Documentation Feedback

Product Folder Link(s): ADS5463 ADS54RF63

ADS54RF63IPFPR bảng dữ liệu(PDF) 32 Page - Texas Instruments

ADS54RF63IPFPR bảng dữ liệu(HTML) 32 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

bảng dữ liệu tải về

Link URL