STC3115AIQT datasheet(20/31 Pages) STMICROELECTRONICS

20 / 31 page

I2C interface

STC3115

20/31

DocID023755 Rev 4

I2C interface

7.1

Read and write operations

The I2C interface is used to control and read the current accumulator and registers. It is

compatible with the Philips I2C Bus® (version 2.1). It is a slave serial interface with a serial

data line (SDA) and a serial clock line (SCL).

•

SCL: input clock used to shift data

•

SDA: input/output bidirectional data transfers

A filter rejects the potential spikes on the bus data line to preserve data integrity.

The bidirectional data line supports transfers up to 400 Kbit/s (fast mode). The data are

shifted to and from the chip on the SDA line, MSB first.

The first bit must be high (START) followed by the 7-bit device address and the read/write

control bit. Bits DevADDR0 to DevADDR2 are factory-programmable, the default device

address value being 1110 000 (AddrID0 = AddrID1 = AddrID2 = 0). The STC3115 then

sends an acknowledge at the end of an 8-bit long sequence. The next eight bits correspond

to the register address followed by another acknowledge.

The data field is the last 8-bit long sequence sent, followed by a last acknowledge.

Table 9. Device address format

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

1110

DevADDR2

DevADDR1

DevADDR0

R/W

Table 10. Register address format

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

RegADDR7

RegADDR6

RegADDR5

RegADDR4

RegADDR3

RegADDR2

RegADDR1

RegADDR0

Table 11. Register data format

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

DATA7

DATA6

DATA5

DATA4

DATA3

DATA2

DATA1

DATA0

STC3115AIQT bảng dữ liệu(PDF) 20 Page - STMicroelectronics

STC3115AIQT bảng dữ liệu(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

bảng dữ liệu tải về

Link URL