HCPL-M601 datasheet(7/11 Pages) AVAGO

7 / 11 page

Notes:

1. Bypassing of the power supply line is required with a 0.1 μF ceramic disc capacitor adjacent to each optocoupler. The total lead length be-

tween both ends of the capacitor and the isolator pins should not exceed 10 mm.

2. Peaking circuits may produce transient input currents up to 50 mA, 50 ns maximum pulse width, provided average current does not exceed

20 mA.

3. Device considered a two terminal device: pins 1 and 3 shorted together, and pins 4, 5 and 6 shorted together.

4. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage ≥ 4500 VRMS for 1 second (Leakage detec-

tion current limit, II-O ≤ 5 μA).

5. The tPLH propagation delay is measured from 3.75 mA point on the falling edge of the input pulse to the 1.5 V point on the rising edge of the

output pulse.

6. The tPHL propagation delay is measured from 3.75 mA point on the rising edge of the input pulse to the 1.5 V point on the falling edge of the

output pulse.

7. CMH is the maximum tolerable rate of rise of the common mode voltage to assure that the output will remain in a high logic state (i.e., VOUT >

2.0 V).

8. CML is the maximum tolerable rate of fall of the common mode voltage to assure that the output will remain in a low logic state (i.e., VOUT > 0.8

V).

9. For sinusoidal voltages, (|dVCM|/dt)max =

SfCMVCM(p-p).

10. See application section; “Propagation Delay, Pulse-Width Distortion and Propagation Delay Skew” for more information.

11. tPSK is equal to the worst case diﬀerence in tPHL and/or tPLH that will be seen between units at any given temperature within the worst case

operating condition range.

Switching Speciﬁcations

Over recommended temperature (TA = -40°C to 85°C), VCC = 5 V, IF = 7.5 mA unless otherwise speciﬁed.

Device

Parameter

Symbol

HCPL-

Min.

Typ.*

Max.

Unit

Test Conditions

Fig.

Note

Propagation

tPLH

TA = 25°C

RL = 350 Ω

6, 7

Delay Time

to High

100

CL = 15 pF

Output Level

Propagation

tPHL

TA = 25°C

6, 7

Delay Time

to Low

100

Output Level

Propagation

tPSK

10,

Delay Skew

Pulse Width

|tPHL - tPLH|

3.5

Distortion

Output Rise

trise

Time

(10%-90%)

Output Fall

tfall

Time

(10%-90%)

Common

|CMH|

M600

10,000

V/μs

VCM = 10 V

VO(min) = 2 V

7, 9

M601

5,000

10,000

VCM = 50 V

M611

10,000

15,000

VCM = 1000 V

Common

|CMH|

M600

10,000

VCM = 10 V

VO(max) = 0.8 V

8, 9

M601

5,000

10,000

VCM = 50 V

M611

10,000

15,000

VCM = 1000 V

*All typicals at TA = 25°C, VCC = 5 V.

Mode Transient

Immunity at High

Output Level

Mode Transient

Immunity at Low

Output Level

RL = 350 Ω

IF = 7.5 mA

TA = 25°C

RL = 350 Ω

IF = 0 mA

TA = 25°C

HCPL-M601 bảng dữ liệu(PDF) 7 Page - AVAGO TECHNOLOGIES LIMITED

HCPL-M601 bảng dữ liệu(HTML) 7 Page - AVAGO TECHNOLOGIES LIMITED

Html Pages

1 2 3 4 5 6 7 8 9 10 11

bảng dữ liệu tải về

Link URL