SATA-Disk Module 4

APSDMxxxx45AX-PXX

1

© 2014 Apacer Technology Inc.

Rev. 1.4

Features:

Standard Serial ATA Compliance

–

Serial ATA Revision 2.6

–

SATA 3.0 Gbps

–

ATA-compatible command set

Capacities

–

2, 4, 8, 16, 32, 64 GB

Performance*

–

Burst read/write: 300 MB/sec

–

Sustained read: up to 165 MB/sec

–

Sustained write: up to 150 MB/sec

Intelligent endurance design

–

Built-in hardware ECC, enabling up to

16/24 bit correction per 1K bytes

–

Static wear-leveling scheme together

with dynamical block allocation to

significantly increase the lifespan of a

flash device and optimize the disk

performance

–

Flash bad-block management

–

S.M.A.R.T.

–

Power Failure Management

–

ATA Secure Erase

–

TRIM

NAND Flash Type: SLC

Temperature ranges

–

Operation: 0°C to 70°C (32 ~ 158°F)

–

Extended: -40 ~ +85°C (-40°~ 185°F)

–

Storage: -40°C to 100°C (-40°~ 212°F)

Supply voltage

–

5.0 V

± 5%

Power consumption (typical)*

–

Active mode: 333 mA@5.0 V

–

Idle mode: 95 mA@5.0 V

Connector type

–

7-pin SATA signal connector

–

15-pin SATA power connector

Form factor

–

SATA Disk Module

–

Dimension: 45.80x32.80x1.00**, unit: mm

Shock & Vibration***

–

Shock: 1500 G

–

Vibration: 15 G

RoHS compliant

*Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations

or platform settings. The term idle refers to the standby state of the device.

**Excluding the thickness/height of chips and connector, only the thickness of the module is accounted.

***Non-operating