User's Guide

SWRU197H – September 2010 – Revised April 2014

CC Debugger

1

Introduction

The CC Debugger is primarily used for Flash programming and debugging software running on CCxxxx

8051-based System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these

purposes are the SmartRF™ Flash Programmer [9] from Texas Instruments and IAR Embedded

When connected to the debugger, the SoC devices can be controlled directly from SmartRF™ Studio [8].

SmartRF Studio is also able to control supported CCxxxx RF transceivers (CC2520, CC2500, CC110x,

CC11xL, CC112x, CC120x) when they are connected to the debugger as explained in Section 6.3.

In addition, the CC Debugger is used for configuring the CC85xx devices with the PurePath Wireless

Configurator [12] and controlling them with the PurePath Wireless Commander [13].

SmartRF is a trademark of Texas Instruments.

IAR Embedded Workbench is a registered trademark of IAR Systems AB.

Windows Vista is a registered trademark of Microsoft Corporation in the United States and other countries.

Microsoft is a registered trademark of Microsoft Corporation in the United States and/or other countries, or both.

Windows is a registered trademark of Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

All other trademarks are the property of their respective owners.

4

CC Debugger

SWRU197H – September 2010 – Revised April 2014

Submit Documentation Feedback

Copyright © 2010–2014, Texas Instruments Incorporated