Embedded Artists AB

Davidshallsgatan 16

SE-211 45 Malmö

Sweden

Phone/Fax: +46 (0)40-611 00 93

E-mail: info@embeddedartists.com

http://www.embeddedartists.com

© Copyright 2012 Embedded Artists AB. All rights reserved. All other products or service names mentioned herein are

trademarks of their respective holders and should be treated as such.

Embedded Artists’

LPC4088 OEM Board DS rev A DS

The Art of Embedded Systems Development – made Easy™

Document status: Preliminary

Absolute Maximum Ratings

Stress above these limits may cause permanent damage to the board.

Technical Data

Mechanical Dimensions

Board width according to SO-DIMM standard: 67.6 mm.

Board height and depth according to picture below:

ESD CAUTION

ESD (electrostatic discharge) sensitive device. Charged devices and circuit boards can

discharge without detection. Although this product features ESD protection damages may

occur on devices subjected to high energy ESD. Therefore, proper ESD precaution should be

taken to avoid performance degradation or loss of functionality.

Parameter

Rating

VDD to GND (Supply voltage)

-0.5V to +3.6V

General for Digital/Analog Input/Output Voltage

+5V tolerant pins on LPC4088

-0.5V to VDD+0.5V

-0.5V to +6.0V (see LPC4088 DS for details)

Storage temperature

-40°C to 100°C

Parameter

Min

Typical

Max

Supply voltage (VDD to GND)

Ripple with frequency contents < 100kHz

Ripple with frequency contents ≥ 100kHz

3.10V

3.30V

3.50V

50mV

10mV

Supply current

- idle, 32kHz RTC active

- low-power mode

- executing from internal flash (120MHz)

- executing from external sdram (120MHz)

- Ethernet+usb active

Max observed

VBAT current

Relative Humidity (RH)

5%

5%

5%

80%

50%

35%

Top side components

Bottom side components

50.0 mm

5.0 mm

2.0 mm

2.0 mm