http://www.tracopower.com

Page 3 of 4

All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.

DC/DC Converters

THL 10WI Series

10 Watt

General Specifications

Temperature ranges

– Operating without heat sink

–40°C to +75°C (with derating)

– Operating with heat sink

–40°C to +85°C (with derating)

– Case temperature

+100°C max.

– Storage

–40°C to +125°C

Power derating

– Operating without heat sink

2.5 %/K above +60°C

– Operating with heat sink

3.5 %/K above +70°C

Thermal inpedance

– Natural convection

18.2°C/W

– Natural convection with heat sink

15.8°C/W

Humidity (non condensing)

95 % rel H max.

Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign)

>350’000 h

Isolation voltage (60 sec.)

– Input/Output

1’500 VDC

Isolation capacitance

– Input/Output

1200 pF max.

Isolation resistance

– Input/Output (500 VDC)

>1’000 MOhm

Remote On/Off

– On:

2.5 ... 50 VDC or open circuit

– Off:

0 ... +1.0 VDC or short circuit pin 6 and pin 2

– Off idle current:

10 mA max.

Switching frequency (fixed)

400 kHz typ. (pulse width modulation PWM)

Altitude during operation

5‘000 m max. (16‘400 ft) approved

Safety standards

UL/cUL 60950-1, IEC/EN 60950-1

Safety approvals

– UL/cUL

(entry pending)

– CB test certificate according IEC 60950-1

www.tracopower.com/products/thl10wi-cb.pdf

– CSA certificate for UL/cUL 60950-1

www.tracopower.com/products/thl10wi-csa.pdf

Environmental compliance

– Reach

www.tracopower.com/products/thl10wi-reach.pdf

– RoHS

RoHS directive 2002/95/EC

Physical Specifications

Casing material

metal

Baseplate

non conductive FR4

Potting material

epoxy (UL 94V-0 rated)

Weight

15 g (0.53oz)

Soldering temperature

max. +260°C / 10sec.