ATF1502AS datasheet(6/18 Pages) ATMEL

6 / 18 page

ATF1502AS

JTAG-BST/ISP Overview

The JTAG boundary-scan testing is controlled by the Test

Access Port (TAP) controller in the ATF1502AS. The

boundary-scan technique involves the inclusion of a shift-

to each component so that signals at component bound-

aries can be controlled and observed using scan testing

methods. Each input pin and I/O pin has its own boundary

scan cell (BSC) to support boundary scan testing. The

ATF1502AS does not include a Test Reset (TRST) input

pin because the TAP controller is automatically reset at

power up. The five JTAG modes supported include: SAM-

PLE/PRELOAD, EXTEST, BYPASS, IDCODE and HIGHZ.

The ATF1502AS’s ISP can be fully described using JTAG’s

BSDL as described in IEEE Standard 1149.1b. This allows

ATF1502AS programming to be described and imple-

mented using any one of the 3rd party development tools

supporting this standard.

The ATF1502AS has the option of using four JTAG-stan-

dard I/O pins for boundary scan testing (BST) and in-sys-

tem programming (ISP) purposes. The ATF1502AS is

programmable through the four JTAG pins using the IEEE

standard JTAG programming protocol established by IEEE

Standard 1149.1 using 5V TTL-level programming signals

from the ISP interface for in-system programming. The

JTAG feature is a programmable option. If JTAG (BST or

ISP) is not needed, then the four JTAG control pins are

available as I/O pins.

JTAG Boundary Scan Cell (BSC)

Testing

The ATF1502AS contains up to 32 I/O pins and 4 input

pins, depending on the and package type selected. Each

input pin and I/O pin has its own boundary scan cell (BSC)

in order to support boundary scan testing as described in

detail by IEEE Standard 1149.1. Typical BSC consists of

three capture registers or scan registers and up to two

update registers. There are two types of BSCs, one for

input or I/O pin, and one for the macrocells. The BSCs in

the device are chained together through the capture regis-

ters. Input to the capture register chain is fed in from the

TDI pin while the output is directed to the TDO pin. Capture

registers are used to capture active device data signals, to

shift data in and out of the device and to load data into the

update registers. Control signals are generated internally

by the JTAG TAP controller. The BSC configuration for the

input and I/O pins and macrocells are shown below.

BSC Configuration for Input and I/O

Pins (except JTAG TAP Pins)

Note:

The ATF1502AS has pull-up option on TMS and TDI

pins. This feature is selected as a design option.

DC and AC Operating Conditions

Commercial

Industrial

Operating Temperature (Case)

°C - 70°C-40°C - 85°C

CCINT or VCCIO (5V) Power

Supply

± 5%

± 10%

CCIO (3.3V) Power Supply

3.0V - 3.6V

ATF1502AS bảng dữ liệu(PDF) 6 Page - ATMEL Corporation

ATF1502AS bảng dữ liệu(HTML) 6 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

bảng dữ liệu tải về

Link URL