All dimensions are in inches and metric. All specifications are to the latest revisions. Specifications are subject to change without notice.

Registered trademarks are the property of their respective companies. Made in USA

5/21/02 SY/EH/LS

PomonaACCESS 90117 (800) 444-6785 or (425) 446-6010

Last saved by PN

More drawings available at www.pomonaelectronics.com

S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_5285_2_02.doc

Page 2 of 2

Model 5285 & Assembly Instructions

Cable Plug, BNC Male, Crimp On R658C

Sales: 800-490-2361 Fax: 888-403-3360

Technical Assistance: 800-241-2060

FIGURE #1

A.

Strip cable as shown.

FIGURE #2

B.

Fit the center contact over conductor wires, slide until it butts against the dielectric. Crimp or solder.

FIGURE #3

C.

Slide the metal crimp sleeve over cable, then install the connector body until contact locks into connector.

D.

Verify that the knurled ferrule of connector is inserted between the dielectric and the braid.

FIGURE #4

E.

Slide the metal sleeve along the cable unit until it butts against the bottom of connector.

F.

Crimp sleeve using Hex type Die or equivalent.

G.

Retention after crimp is normally 60 lbs./Minute.

Note: Hex Diameter .213/.217 after crimp.