Datasheet

Characteristics

General Performance Characteristics

Characteristic

Description

RF Input

Operating Frequency Range

10 kHz - 6.2 GHz

Maximum Operating Input Level

+20 dBm peak envelope power

This is the maximum input level at which the instrument will meet its performance specifications.

For a signal without any amplitude variation, peak envelope power = rms.

Maximum Input Power without Damage

IF Output

Output Impedance

50 ohms

IF Center Frequency

140 MHz

IF 3 dB Bandwidth

24 MHz

IF Output Level (nominal performance at 0 dBm input)

Input Frequency

IF Output Level

1GHz

-12 dBm

1.6 GHz

-12 dBm

3.6 GHz

-10 dBm

4.35 GHz

-11 dBm

5GHz

-16 dBm

5.75 GHz

-22 dBm

Internal Timebase

Frequency Error (factory calibration corrected)

±0.5 PPM from 0 °C to 50 °C

±1.0 PPM aging/year

Twenty-minute warm-up period required to meet accuracy specification

Frequency Error (GPS corrected)

±0.01 ppm (typical)

Frequency Error (after GPS Lock Loss)

±0.03 ppm, 10 minute interval after Lock Loss (unit operated for >20 minutes before Lock Loss and < 5 °C temperature

change over interval) (typical)

External Reference Input

Impedance

1500 ohm

Frequency Range

1 MHz up to 20 MHz ± 1 PPM in 1 MHz steps

Input Level Range

-15 dBm to +15 dBm, 1 MHz to 15 MHz

-10 dBm to +15dBm, 16MHz to 20 MHz

dBm levels assume 50 ohm source

Integrated GPS receiver

Position Accuracy (typical)

Horizontal: R < 9 meters (P = 90%)

Altitude: H < 18 meters (P = 90%)

Position Update Rate (nominal)

1 update/sec (Latitude/Longitude/Altitude)

Spectrum Analyzer Characteristics

Characteristic

Description

Frequency

Span

10 kHz to 6.2 GHz preamp off

10 MHzto6.2 GHzpreampon

Center Frequency Setting Resolution

1Hz

Swept Spans (wide scanning)

Span Range

20 MHz to 6.2 GHz

Spectrums per second

61 (typical)

Scan Speed

1240 MHz per second (Typical)