AT24C01A datasheet(22/24 Pages) ATMEL

22 / 24 page

AT24C01A/02/04/08A/16A

0180V–SEEPR–8/05

5TS1 – SOT23

1150 E. Cheyenne Mtn. Blvd.

Colorado Springs, CO 80906

TITLE

DRAWING NO.

REV.

PO5TS1

6/25/03

COMMON DIMENSIONS

(Unit of Measure = mm)

SYMBOL

MIN

NOM

MAX

NOTE

5TS1, 5-lead, 1.60 mm Body, Plastic Thin Shrink

Small Outline Package (SHRINK SOT)

–

1.10

0.00

–

0.10

0.70

0.90

1.00

0.08

–

0.20

2.90 BSC

2, 3

2.80 BSC

2, 3

1.60 BSC

2, 3

0.60 REF

0.95 BSC

1.90 BSC

0.30

–

0.50

4, 5

NOTES: 1. This drawing is for general information only. Refer to JEDEC Drawing

MO-193, Variation AB, for additional information.

2. Dimension D does not include mold flash, protrusions, or gate burrs.

Mold flash, protrusions, or gate burrs shall not exceed 0.15 mm per end.

Dimension E1 does not include interlead flash or protrusion. Interlead

flash or protrusion shall not exceed 0.15 mm per side.

3. The package top may be smaller than the package bottom. Dimensions

D and E1 are determined at the outermost extremes of the plastic body

exclusive of mold flash, tie bar burrs, gate burrs, and interlead flash, but

including any mismatch between the top and bottom of the plastic body.

4. These dimensions apply to the flat section of the lead between 0.08 mm

and 0.15 mm from the lead tip.

5. Dimension "b" does not include Dambar protrusion. Allowable Dambar

protrusion shall be 0.08 mm total in excess of the "b" dimension at

maximum material condition. The Dambar cannot be located on the lower

radius of the foot. Minimum space between protrusion and an adjacent lead

shall not be less than 0.07 mm.

End View

Seating

Plane

Side View

Top View

AT24C01A bảng dữ liệu(PDF) 22 Page - ATMEL Corporation

AT24C01A bảng dữ liệu(HTML) 22 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

bảng dữ liệu tải về

Link URL