AS1324 datasheet(16/21 Pages) AMSCO

16 / 21 page

www.ams.com/DC-DC_Step-Up/AS1324

Revision 1.06

16 - 21

AS1324

Datasheet - A p p l i c a t i o n I n f o r m a t i o n

9.10 Layout Considerations

The AS1324 requires proper layout and design techniques for optimum performance.

The power traces (GND, SW, and VIN) should be kept as short, direct, and wide as is practical.

Pin VFB (AS1324 only) should be connected directly to the feedback resistors (R1 and R2). A potentiometer as replacement for R1 and R2

should be avoided to minimize the output voltage ripple and to maintain the stability of the regulator.

The resistive divider (R1/R2) must be connected between the positive plate of COUT and ground.

The positive plate of CIN should be connected as close to VIN as is practical since CIN provides the AC current to the internal power MOS-

FETs.

Switching node SW should be kept far away from the sensitive VFB node.

The negative plates of CIN and COUT should be kept as close to each other as is practical. A starpoint to Ground is recommended.

Figure 29. AS1324 Basic PCB Layout

Figure 30. AS1324 Basic Diagram

AS1324

Via to GND

Via to VOUT

VOUT

GND

VIN

Via to VIN

COUT

CIN

CFWD

AS1324

VIN

VFB

GND

CIN

CFWD

High Current Path

VIN

COUT

VOUT

AS1324 bảng dữ liệu(PDF) 16 Page - ams AG