2

SAFETY INSTRUCTIONS

Do not touch the nozzle or molten adhesive with bare skin as they are hot - the operating temperature of this tool is approximately 200ºC.

Protective gloves should always be worn. Careless handling can cause skin burns. If molten adhesive comes into contact with the skin immerse the

affected area immediately in plenty of cold water. Seek medical advice if necessary. In addition to the safety instructions herein, any statutory regulations, local

fire insurance regulations, or other generally valid “regulations for accident prevention” must be complied with when using this tool.

Repairs should only be undertaken by competent personnel with the adequate electrical knowledge. Before proceeding with any maintenance or repair

operation, disconnect the tool from the mains electricity supply. If in doubt, contact your supplier.

Do Not connect to mains supply at this point!

Attach the tool stand.

1

Load the tool by inserting an

adhesive stick into the rear.

2

Operate the trigger to feed the stick

forward until resistance is felt.

3

Connect to mains supply.

4

Wait 5 minutes to warm.

5

Operate the trigger to extrude adhesive until

the stick has been completely drawn into the

rear of the tool.

6