www.ti.com

Using the PC Software

DC analysis section: The results of RMS noise analysis, peak-to-peak analysis, and a running voltage

number are shown in this section. The number of analysis points and the reference voltage used for

voltage calculations are also adjustable here.

Recording section: This feature controls recording of data to a file.

Device control section: This section allows device parameters to be adjusted.

Status display: This display shows messages indicating the current state of the program.

Acquire button: This button starts and stops the running acquisition of data.

4.3

Starting the Program

When the program launches, a screen similar to that shown in Figure 6 appears. Immediately after launch,

the program searches all available serial ports for the board. To do this step, it opens every available

serial port in turn, testing it to see if there is an ADS1232REF connected. The program uses the first

ADS1232REF it finds.

Figure 6. ADS1232REF Software Display

Although this procedure is conceptually simple, it may not go as smoothly as expected. The following

process ensures that the board is found correctly. Note that Steps 1

–3 can be done in any order.

Step 1.

Apply power to the ADS1232REF.

Step 2.

Plug in the USB connector.

Step 3.

Start the program.

Step 4.

Watch the status display. It reads Scanning followed by the name of the serial port being

tested. When the board is found, the display reads Idle. Until a board is found, the display

cycles through every port, spending approximately one second on each port.

Once the board is detected, the program enters Idle mode and is ready for use.

NOTE:

If the board is never detected, it is still possible (and safe) to exit the program during the

search process. If the board does not respond, pressing the USB Reset switch (SW1) may

help.

15

SBAU120B

– November 2005 – Revised July 2011

ADS1232REF User

's Guide

Submit Documentation Feedback

Copyright

© 2005–2011, Texas Instruments Incorporated